BE Forend Direction

Post your questions or seek advise regarding gunsmithing, restoration, repairs, ballistics, etc, etc.
Commercial operations or businesses may not advertise nor appear to advertise their products or services, either directly, or indirectly by a second party, except for simple reference as a source for such products or services
Post Reply
CSURamSkeet
Posts: 1
Joined: Sat Sep 12, 2026 2:46 pm
Has thanked: 1 time
Been thanked: 1 time

BE Forend Direction

Post by CSURamSkeet »

Greetings, Friends,

This is my first post since joining the Collectors Association in August, when I found a 12-ga. BE Grade at a local store for a very reasonable price. A friend pulled the card on this gun, dating it to January 1912. Overall, the gun looked very nice, locks up tight, and the lever is well right of center.

The downside is that, at some point in the gun's life, the forend was replaced with a beavertail, which was then broken and pinned/glued back together. I shot one round of trap, and halfway through the round, the forend started working loose. By the end of the round, the gun was in pieces. I can tell that under recoil, the forend iron (which has matching serial numbers to the barrel and receiver) is floating in the forend wood, creating a gap between the end of the iron and the forend wood.

Rather than trying to bed this iron in already-broken wood, I'm on the lookout for replacement forend wood. There is one listed on GI (listing #103018045). Would this fit my gun? Can anyone with experience see any red flags with this piece of wood, or does another forum member have a better solution?

Thank you all for taking the time to read my post. I've greatly enjoyed lurking around the forum with my morning coffee over the past few months! I appreciate any wisdom or direction for further consideration.

Regards,
CSURamSkeet
Attachments
IMG_1930.jpg
IMG_1929.jpg
ROMAC
Posts: 1486
Joined: Sat Apr 18, 2009 11:16 pm
Location: SE PA
Has thanked: 1057 times
Been thanked: 970 times

Re: BE Forend Direction

Post by ROMAC »

You could try to get an original forend in the rough from Jason Barden of Pumpkin Mountain and have it properly finished. I bet he’d let you ship the metal to him to find one that has the best fitment

He is also qualified to do the entire project but he may not be taking that kind of work on any more.

Try googling him up for his contact information.

Also, a good wood guy could probably fix it so you’d never know something was wrong.
"Somehow, the sound of a shotgun tends to cheer one up" -- Robert Ruark
Post Reply