Stock question...
- Fin2Feather
- Posts: 1007
- Joined: Sun Jan 07, 2007 10:15 am
- Location: Kansas High Plains
- Has thanked: 136 times
- Been thanked: 114 times
Stock question...
I bought a Utica Sterlingworth 12ga. I'm happy with the gun, but there's one thing I don't care for: it has the later uncapped pistol grip. Aside from the fact that it's probably silly, any suggestions as to who might alter the stock and fit a grip cap? Is it possible to do it without refinishing the stock? Thanks...
Utica Fox Appreciation Society - Charter Member
-
- Posts: 426
- Joined: Fri Jan 05, 2007 11:17 pm
- Location: Western PA
- Been thanked: 1 time
The Utica gun that I have is much narrower at the bottom of the pistol grip than the capped stocks. I think you'll end up with a funky shaped cap if you cut it to fit the contour of your stock. If the stock has no other problems, I'm not so sure that you'd really want to do that. The one I have has been hunted pretty hard for the past 20 years and numerous falls to the ground and has yet to get dinged up on the bottom of the grip. Just my 2 cents. Fred
Recoil is most noticed when I miss
- Fin2Feather
- Posts: 1007
- Joined: Sun Jan 07, 2007 10:15 am
- Location: Kansas High Plains
- Has thanked: 136 times
- Been thanked: 114 times