What can be done (restoring engraving)

Silvers · Post by **Silvers** » Fri Mar 07, 2008 1:06 pm

First pic is a CE Fox trigger guard that was buffed before being blued. It must have been heavily corroded. Engraving is pretty much gone on its tail. Guard bow is weak. Serial number gone. No engraving on the trigger guard screw head.

Next few pics show engraving restored. Serial number was also put back on but isn't shown in these pics. Silvers

Fin2Feather · Post by **Fin2Feather** » Fri Mar 07, 2008 9:43 pm

Silvers, are you doing the engraving yourself? If so, nice work.

Fin

Silvers · Post by **Silvers** » Sat Mar 08, 2008 8:17 am

Fin, I wish I could do work like that. It was done by Geoffroy Gournet in Easton, PA. I sent some pics of what it should look like and he took it from there. Frank

FRBRIT · Post by **FRBRIT** » Sat Mar 08, 2008 9:34 am

Now, That's the Ticket! Thanks for sharing!