If you have had a good experience with a gunsmith who repaired your Fox Shotgun, kindly list his name and contact information so others might have a list to review. If this is allowed on this site?
Matt Bagley repaired my broken Fox ejector guide pin last May. he did an Excellent job!
Located in western Ohio
Gunsmiths Who Have Made Fox Repairs fro You?
-
Stan Hillis
- Posts: 2628
- Joined: Sun Nov 09, 2008 8:31 pm
- Location: Jawja
- Has thanked: 612 times
- Been thanked: 734 times
-
Fin2Feather
- Posts: 1023
- Joined: Sun Jan 07, 2007 10:15 am
- Location: Kansas High Plains
- Has thanked: 170 times
- Been thanked: 160 times
Re: Gunsmiths Who Have Made Fox Repairs fro You?
Just got my Fox SBT back from Dennis Potter in Wisconsin for trigger work.
Utica Fox Appreciation Society - Charter Member
-
Mike of the Mountain
- Posts: 1930
- Joined: Thu Aug 08, 2013 4:16 pm
- Location: Springville, PA
- Has thanked: 81 times
- Been thanked: 70 times
- Contact:
-
vaturkey
- Posts: 3115
- Joined: Wed Nov 26, 2008 6:33 pm
- Location: Hamilton, VA
- Has thanked: 558 times
- Been thanked: 868 times
Re: Gunsmiths Who Have Made Fox Repairs fro You?
Do not disagree, but he won't be doing the work. I think he is more of a shop foreman now and does QC oversight. G&H has 3 or 4 full time Gunsmiths on staff.
-
brushbuster
- Posts: 96
- Joined: Fri Oct 09, 2015 3:03 pm
- Has thanked: 49 times
- Been thanked: 67 times
Re: Gunsmiths Who Have Made Fox Repairs fro You?
Has anyone used G&H for choke work and rust bluing barrels? They are local to me so no shipping seems like a nice option.
I’ve had them do some work on my other guns including my Beretta DT11 and it was always top notch.
I’ve had them do some work on my other guns including my Beretta DT11 and it was always top notch.
-
vaturkey
- Posts: 3115
- Joined: Wed Nov 26, 2008 6:33 pm
- Location: Hamilton, VA
- Has thanked: 558 times
- Been thanked: 868 times
Re: Gunsmiths Who Have Made Fox Repairs fro You?
I truly think they would do a fine job. They have a full service shop and as I mentioned earlier Dan Rossiter rides herd on everything that comes out of there. If I could drop off my shotguns at a qualified well known shop versus shipping them, it would be a no brainer. PS. I use Matthew Begley for most everything now, but he has a one year backup and is taking on no new work as others have mentioned.brushbuster wrote: ↑Tue Dec 20, 2022 11:05 am Has anyone used G&H for choke work and rust bluing barrels? They are local to me so no shipping seems like a nice option.
I’ve had them do some work on my other guns including my Beretta DT11 and it was always top notch.