case color

[lynn deforest]

How do you preserve the case color on a Sterlingworth that is to be used for sporting clays and hunting? The present condition has been appraised at 90%.

[deweyvicknair]

The two factors that most affect case colors are abrasion (handling) and UV exposure (sunlight). The goal would be to minimize both. Don't carry it by the frame and case it when not shooting. I realize that this might be a bit cumbersome but it is the best way to preserve the colors.





www.vicknairrestorations.com

[mike campbell]

If you can disassemble it, spraying it with lacquer will help.

[bamboozler]

If you can disassemble it, spraying it with lacquer will help.

Undoubtedly, Mike's suggestion above would be the best way to slow the process of case color wear, the late Dr. Oscar Gaddy recommended using Behlen's spray lacquer. This method, however; requires disassembly and reassembly when finished---so there's always the chance of buggering something up if you do so.

I found similar results can be achieved without disassembly/reassembly by simply purchasing a 3 oz. bottle of "Case Color Lacquer" from Galazan's and applying it directly to the frame (after degreasing of course) with a 1/4" camel hair artist's brush. With a steady hand you can apply it without getting any of the lacquer on the wood. (If you slip up and get some on the wood you can simply wipe it off with a cotton rag). The product goes on very thin and dries in a couple of minutes or so, I found that about 2-3 coats is sufficient to give ample protection without taking away any of the engraving definition. Note: Galazan's Case Color Lacquer will leave a slight amber hue.

[ASavageFox]

I use Galazan's product also. I just wipe it on with a lint free cloth after a thorough cleaning.

[lee r moege]

Something else I have used as a tip from the Parker boys is Tru Oil. The Parker reproductions shed their color very easily and putting Tru Oil on the frame slows this. The gun does not have to be disassembled but does have to be clean. One can mask the stock off if you wish, clean the metal with alcohol, and apply the oil with your fingers in a light coat. It dries hard in a couple days, doesn't come off in chips, and is easy to apply and re-apply. Lee.