BE Forend Direction
Posted: Thu Nov 19, 2026 8:20 am
Greetings, Friends,
This is my first post since joining the Collectors Association in August, when I found a 12-ga. BE Grade at a local store for a very reasonable price. A friend pulled the card on this gun, dating it to January 1912. Overall, the gun looked very nice, locks up tight, and the lever is well right of center.
The downside is that, at some point in the gun's life, the forend was replaced with a beavertail, which was then broken and pinned/glued back together. I shot one round of trap, and halfway through the round, the forend started working loose. By the end of the round, the gun was in pieces. I can tell that under recoil, the forend iron (which has matching serial numbers to the barrel and receiver) is floating in the forend wood, creating a gap between the end of the iron and the forend wood.
Rather than trying to bed this iron in already-broken wood, I'm on the lookout for replacement forend wood. There is one listed on GI (listing #103018045). Would this fit my gun? Can anyone with experience see any red flags with this piece of wood, or does another forum member have a better solution?
Thank you all for taking the time to read my post. I've greatly enjoyed lurking around the forum with my morning coffee over the past few months! I appreciate any wisdom or direction for further consideration.
Regards,
CSURamSkeet
This is my first post since joining the Collectors Association in August, when I found a 12-ga. BE Grade at a local store for a very reasonable price. A friend pulled the card on this gun, dating it to January 1912. Overall, the gun looked very nice, locks up tight, and the lever is well right of center.
The downside is that, at some point in the gun's life, the forend was replaced with a beavertail, which was then broken and pinned/glued back together. I shot one round of trap, and halfway through the round, the forend started working loose. By the end of the round, the gun was in pieces. I can tell that under recoil, the forend iron (which has matching serial numbers to the barrel and receiver) is floating in the forend wood, creating a gap between the end of the iron and the forend wood.
Rather than trying to bed this iron in already-broken wood, I'm on the lookout for replacement forend wood. There is one listed on GI (listing #103018045). Would this fit my gun? Can anyone with experience see any red flags with this piece of wood, or does another forum member have a better solution?
Thank you all for taking the time to read my post. I've greatly enjoyed lurking around the forum with my morning coffee over the past few months! I appreciate any wisdom or direction for further consideration.
Regards,
CSURamSkeet