Page 1 of 1

Fox 12ga Top Lever

Posted: Thu May 23, 2019 9:07 am
by Milesview
I would like to know if my top lever is slightly to the left do I have a problem ?

Thanks

Re: Fox 12ga Top Lever

Posted: Thu May 23, 2019 9:34 am
by Silvers
For A H Fox shotguns - open and close the known to be unloaded gun normally (not easing the lever left). Remove the forend and try to wiggle the barrels side to side and up/down. Any movement indicates wear in the lever/locking mechanism and/or with the hinge pin and barrel hook. To be evaluated and repaired by a competent Fox 'smith. On the other hand if no movement can be felt I wouldn't worry about lever slightly left until a future check shows the start of movement as described.

Just an aside: once in a while you'll see classic double guns advertised with something like this: "a little loose with forend off and tight with forend on". A nice sounding phrase coined by those who don't understand the mechanics or are trying to sell guns that need work.

frank

Re: Fox 12ga Top Lever

Posted: Thu May 23, 2019 3:48 pm
by Jeff S
"Just an aside: once in a while you'll see classic double guns advertised with something like this: "a little loose with forend off and tight with forend on". A nice sounding phrase coined by those who don't understand the mechanics or are trying to sell guns that need work."

Frank, thanks for the wise advice. I thought about your comment as I was reading GI posting 101226702 just a few minutes ago. :)

Re: Fox 12ga Top Lever

Posted: Tue May 28, 2019 2:44 pm
by Milesview
Thanks for the information, very helpful