Fox Collectors

Just to show what can be done with laser welding. The “filler rod” was C 1045 steel. I posted these pics once before and wrote that the welding outfit was not soliciting gunsmithing type work. But despite that I had many requests for the contact info. PLEASE once again, no requests for that info which I’ll have to decline - it's not my choice to do that. But with all said your gunsmith should be able to find a professional laser welder if you need similar work done.

Frank, is the brass round stock in the third photo used as a contact point for the welder or something more mysterious? Also, is the fixture in the fourth picture a radius gauge or does it have another purpose? This procedure is very interesting. Fred

Fred, I taped brass rods to the ribs to act as heat sinks but as it turned out the welding tech relayed, they were totally unnecessary. Notice the yellow electrical tape isn't melted at all. A very COOL procedure. The fixture in the 4th pic is a mandrel of sorts for the draw filing, to prevent the files from cutting/rounding the sharp corner at the muzzle. I'm sure you know the blue coloring is dykem. Frank

Thanks Frank. Now I get what's going on there. Good idea on the muzzle fixture. At this end of PA, up near my camp, there is a micro weld company in Meadville. I'm going to check them out this summer and find out what all they can do on firearms and maybe get a look at the equipment and what is involved in the process. Like most of us, I find the restoration of our old double guns most interesting.

One more question, do you need to bead blast the pits to remove all rust or does the weld pull the slag to the surface?

Fred, good luck on checking out the place in Meadville. The first pic shows the barrel as shipped. Second and third as returned. I wasn't there during the welding so I don't know for sure, but I don't see any evidence of bead or abrasive blasting. Thus I'm assuming the laser process vaporizes the oxide (rust), or rust was ground out first using a tiny burr and a die grinder, or maybe even scratched out with a sharp pin or similar. I do know the laser welding is done under a strong optical magnifier.