Page 1 of 1
Fox Skeet bore choke restrictions
Posted: Tue Jul 31, 2012 9:35 pm
by Twice Barrel
I don't remember ever seeing this subject discussed so I have to ask some folks that are more knowledgeable of Fox guns if they know. The question is did Fox/Savage have specific choke restrictions for guns ordered in Skeet configuration or was choke restriction left to the buyer to specify?
Re: Fox Skeet bore choke restrictions
Posted: Wed Aug 01, 2012 8:07 am
by Silvers
Here are the specs for the right barrel choking in two typical Fox Skeet & Upland 12 gauge guns:
#1.... bore .731, choked to .724, then reverse-choked to .742 at the muzzle (hourglass profile like the Winchester WS-1 choke)
#2.... bore .729, choked to .724, then reverse-choked to .743 at the muzzle (ditto above)
The reverse or "bell choke" at the muzzle is about 1.00" long
Silvers
Re: Fox Skeet bore choke restrictions
Posted: Wed Aug 01, 2012 9:58 am
by mc15426378
Here's a photo of the right barrel on my late 30s Skeet & Upland 12 ga. Don't have my specs handy but if I remember correctly the left barrel is choked approx .004.
Re: Fox Skeet bore choke restrictions
Posted: Wed Aug 01, 2012 12:18 pm
by Twice Barrel
Silvers if I am interpreting your post correctly for a 12 gauge gun the the skeet chokes run approximately .005 to .007 with a bell of .010. Is that correct? Interesting that Savage copied a Winchester design.
Re: Fox Skeet bore choke restrictions
Posted: Wed Aug 01, 2012 2:03 pm
by Silvers
I'm not sure which came first, the WS-1 choke, or the Fox Skeet choke. Parallel path research, or one company copying the other's design? The Fox "bell" is something like .018" > the
choke diameter, measured at the muzzle. And is about .012" > the
bore diameter in the two examples I cited.
It would be interesting to do some comparison patterning of the Fox Skeet choke with bare shot loads the gun was designed for, versus modern plastic shotcup type shells. Good subject for a newsletter article....
Silvers