Page 1 of 1
Bending a Sterlingworth Stock
Posted: Sun Aug 22, 2010 12:12 pm
by nca225
Hi all,
I'm a little skeptical of the idea of bending an 80 year old piece of wood, but that 3" drop is killing me. Is this even feasible and if so how much could I expect it to be raised by? Any recommendations on who who could bend the stock and perhaps "refresh" the wood finish would be appreciated.
Thanks,
-Chris
Re: Bending a Sterlingworth Stock
Posted: Sun Aug 22, 2010 2:00 pm
by bamboozler
I had a 20-ga. Sterlingworth stock that had a 2 3/4" drop that I asked Mike Orlen to bend up as far as he felt comfortable doing, he returned it having a 2 3/8" drop at heel. Your results may vary...
Re: Bending a Sterlingworth Stock
Posted: Sun Aug 22, 2010 3:58 pm
by ATP
Hello Chris,
We have had very good luck with bending 1/2" to 3/4" up or down. It will depend on the condition of your stock but we have bent stocks much older than yours with good results. If you need more information let me know....
Regards,
A. T. Patti
Re: Bending a Sterlingworth Stock
Posted: Mon Aug 23, 2010 8:03 pm
by nca225
ATP,
How often do you get results like that and what process do you employ o bend the stock? Please feel free to email at...
nca225@yahoo.com
-Chris
Re: Bending a Sterlingworth Stock
Posted: Wed Aug 25, 2010 7:26 am
by Sam Ogle
If these fellows say they can do it..........they can.
They are superb 'smiths, who know what they are doing.
Sam Ogle, Lincoln, NE