stock length needed

Post your questions or seek advise regarding gunsmithing, restoration, repairs, ballistics, etc, etc.
Commercial operations or businesses may not advertise nor appear to advertise their products or services, either directly, or indirectly by a second party, except for simple reference as a source for such products or services
Post Reply
falo308
Posts: 9
Joined: Wed Jun 11, 2014 4:15 pm

stock length needed

Post by falo308 »

Hello everyone....im new here and this is my first post......i just got a 1928 sterlingworth that has no buttstock...i got a 95% semi finished and inletted stock and it seems very long...can some measure their stock length for me ...not needing length of pull..just the the overall lenght of the stock itself....12ga sterlingworth
Top
bbman3
Posts: 1632
Joined: Fri Jan 05, 2007 10:13 pm
Location: Deep South
Has thanked: 186 times
Been thanked: 125 times
Contact:
Contact bbman3

Re: stock length needed

Post by bbman3 »

Welcome ! I measured my 20 ga sterlingworth ejector and it measured 15 inches to end of wood,Butt plate not included. I checked a show me semi inlet stock and it was 16 1/8 inches overall.Semi inlet stocks vary and you can request them extra long. Bobby :D
Top
Post Reply

Return to “"Technicana" and Restoration Forum”